A mobile inspection robot with a camera arm beside a gauge cabinet and a gantry on an industrial site at sunset
AI-generated illustration

Robots in oil and gas UAE: what ADNOC's 70 robotics use cases show

Zeta42 · 9 November 2026

ADNOC reports 70 robotics use cases and 200+ AI applications. Here is what a UAE operations buyer can take from it, at any scale.

Robots in oil and gas in the UAE: what ADNOC's 70 robotics use cases show

Robots in oil and gas in the UAE have moved from pilots to a planned portfolio. According to Khaleej Times, ADNOC is expanding AI and robotics across its energy operations, with more than 200 AI applications and 70 robotics use cases either deployed or in development. The aims it reports are automating industrial tasks, predicting equipment failures and improving production efficiency.

Where ADNOC is putting robots

The report says ADNOC has outlined robotics for drilling, production, infrastructure, logistics and shipping. Robots and drones are being developed for inspections, pipeline monitoring, emissions detection and hazardous work.

One example is already in the field. In May, a heavy-duty inspection robot was deployed at the Taweelah Gas Compression Plant, fitted with thermal cameras and sensors. A heavier operator robot, built to work valves and gauges, is still in development.

The pattern is worth copying at any scale. The first robots go to jobs that are repetitive, dangerous or hard to reach, where a sensor reading or a camera image is the main output. Work that needs judgement stays with people.

AI watches the data, robots do the walking

At ADNOC Offshore, Khaleej Times reports an intelligent operating centre that uses AI to monitor operations and help frontline teams spot problems before they affect production. It is meant to help engineers anticipate failures and bring data-driven decisions closer to the staff on offshore assets.

Read together, the two pieces fit. Inspection robots collect readings that used to depend on a person making a round, and software turns those readings into early warnings. A plant that wants one without the other ends up with either data nobody collects or robots nobody can use.

Skills decide whether it works

The article states that more than 40,000 ADNOC employees received AI training over the past two years, and that thousands of AI agents built by employees have been deployed. It also says success depends on combining engineers' domain expertise with the skills of AI developers.

The same holds for a factory or workshop with far smaller numbers. A robot that operators do not trust sits idle. At Zeta42 we time the job first, supply the robot, integrate it and train the operators, and our industrial robotics work follows that order for the same reason.

Security and responsibility stay on the table

The panel coverage also raises security. The SLB chief executive warned about the security and reliability of the data fed into AI systems, and the Halliburton chief executive said IT and OT risks are converging. The article adds that final responsibility stays with people.

For a buyer, that means asking early which network a robot sits on, who can change its tasks and who signs off when it flags a fault.

What a UAE operations buyer can take from it

Few companies will run 70 robotics use cases. The approach still scales down to a single cell or a single inspection route.

  • Start with one job that is repetitive or hazardous and has a clear measure, such as inspection rounds per shift.
  • Decide where the data goes before the robot arrives, and who reads it.
  • Train the operators and supervisors who will live with the robot, not only the engineers who install it.
  • Keep a named person responsible for the robot's decisions and faults.

If you are weighing a first robot for a factory floor, our collaborative robot arms are a practical place to start, and we can time your task before you commit.

Common questions

What are ADNOC's robots used for?
According to Khaleej Times, ADNOC is developing robots and drones for inspections, pipeline monitoring, emissions detection and hazardous work, across drilling, production, infrastructure, logistics and shipping.
Where should a UAE company start with industrial robots?
Start with one repetitive or hazardous job that has a clear measure, decide where its data goes, and train the operators who will use the robot before it arrives.
Does a small factory need AI to use a robot?
No. A robot arm can do a timed, repeatable task on its own. AI becomes useful when you want the robot's readings turned into early warnings.

Source: khaleejtimes.com

ADNOCindustrial robotsinspection robotsUAE industryrobotics training

From Zeta42

Related programmes

Keep reading

Related articles