DOBOT Magician: Basic Version
Basic Version
Supplied, integrated and supported by Zeta42 across the UAE and the GCC, with the engineering to put it into a line and the training for the people who will run it afterwards.
What it does
Built for.
- Described by DOBOT as the world's first desktop-grade 4-axis robot
- Teaches robotic systems, the DH convention, motion control and programming
- Offline mode via internal command storage · multi-robot cooperation
- SDK with communication protocol and program library; ROS and PLC demos
Where it is used
Applications.
- 3D printing: 150 × 150 × 150 mm, PLA, 0.1 mm resolution
- Laser engraving: 500 mW, 405 nm blue laser
- Calligraphy, writing, drawing and gray engraving
- Pick-and-place via suction cup or gripper
Specifications
The full sheet.
- End Effectors Vacuum pump Kit, Gripper, Writing and Drawing Kit, 3D Printing Kit
- 4 axes · payload 500 g · max reach 320 mm · repeatability ±0.2 mm
- 13 interface ports: 10 configurable I/O, 4 × 12 V outputs, UART, 2 × stepper
- Speeds 320°/s (J1 to J3) and 480°/s (J4) at 250 g load
- Software: DobotLab, DobotStudio, Repetier Host, GrblController, DobotBlockly
Figures published by DOBOT. Performance figures are laboratory results and vary with the application.
Specifications published by DOBOT: Magician on dobot-robots.com.
In the same range
Education robots.
- Magician Lite
- Vision Kit
- MagicianGo
- Magician E6 Robot
- E6 AMMR: Autonomous Mobile Manipulation Base
- Training System Without PLC
Specification sheets answer the second question. The first one is usually whether a robot suits the job at all, and that is answered by watching the task rather than by reading a table, which is what an assessment visit is for.
Pricing is quoted case by case.